# Throat thickness

Source: https://www.therness.com/glossary/throat-thickness/
Language: en

Welding glossary

Throat thickness is the shortest distance from the root of a fillet weld to its face, the internal dimension used in structural calculations rather than the leg length shown on a drawing.

Symbol

a

Unit

mm (in, in ASME and AWS practice) — measured on the weld cross-section, not the visible leg

Formula

For a standard equal-leg fillet weld deposited at the theoretical 45-degree profile, effective throat a = leg size z multiplied by the cosine of 45 degrees

[Fillet weld size calculator](https://www.therness.com/tools/fillet-weld-size-calculator/)

Full guide

[Throat thickness: the long-form guide](https://www.therness.com/blog/weld-joint-design-types-sizing-iso-acceptance-criteria/)

This page defines the term. The guide works through how it is calculated, controlled and evidenced.

Throat thickness is the shortest distance from the root of a fillet weld to its face, and it is the dimension every structural calculation for that weld actually uses — not the leg length that appears as the callout on a fabrication drawing. For a standard equal-leg fillet deposited at the theoretical 45-degree profile, the effective throat is the leg size reduced by a fixed geometric factor, which is why a modest-looking leg produces a noticeably smaller throat and why the two numbers are easy to confuse.

The distinction matters because the two dimensions are decoupled in a way that is invisible on a routine gauge check. A weld can measure the correct leg length and still carry a below-specification throat if its profile is concave, undersized in build-up, or deposited at the wrong angle — [weld pool](https://www.therness.com/glossary/weld-pool/) shape at the moment of solidification sets the actual profile, and the leg gauge alone does not reveal it. This is the practical reason laser or structured-light profilometry, which reconstructs the full cross-sectional profile rather than a single leg reading, is used where throat is the governing requirement.

Throat thickness is the fillet-weld counterpart to [penetration](https://www.therness.com/glossary/penetration/) depth on a groove weld: both are the internal, load-bearing dimension that a visual check of the external weld size does not confirm on its own. And where [weld toe](https://www.therness.com/glossary/weld-toe/) condition governs a joint’s fatigue life, throat thickness governs its static strength — a joint can satisfy one requirement and fail the other, which is why weld joint design treats them as separate checks rather than a single pass/fail on appearance.

## Where you meet this term

- Fillet weld sizing calculations, where throat is the dimension used for shear and bending capacity, not the leg
- Fabrication drawings, where the callout is the leg size while the design calculation behind it is the throat
- Weld profile measurement by laser or structured-light profilometry, one of the few routes that measures it directly
- Butt weld design, where the comparable governing dimension is full or partial joint penetration depth rather than a throat

## Related terms

[Weld toe](https://www.therness.com/glossary/weld-toe/)

The weld toe is the boundary line where the surface of a weld bead meets the surface of the parent material, on either side of the weld.

[Penetration](https://www.therness.com/glossary/penetration/)

Penetration is the depth to which weld metal and the fusion boundary extend into the parent material, measured from the original joint surface inward.

## Applications where it is controlled

Shipbuilding and marine fabrication

### [Weld monitoring for shipbuilding](https://www.therness.com/applications/shipbuilding/)

High-volume welding under classification-society rules. The codes that apply, the four monitoring pain points that cost yards most, and which Therness signal addresses each.

[All glossary terms](https://www.therness.com/glossary/)
