Welding glossary
Essential variable
An essential variable is a welding condition that a procedure qualification depends on: change it beyond the range the qualification supports and the procedure must be requalified, or covered by another qualification record, before welding continues.
An essential variable is a welding condition that the qualification of a procedure depends on. A test weld proves a procedure for the combination of conditions it used, and an essential variable marks a direction in which that proof stops. Move one outside the range the record supports and the WPS built from the PQR no longer covers the job, however the finished weld looks. A new qualification test, or another qualification record that covers the new condition, comes before production welding continues. This entry is about procedure qualification; a welder’s qualification has its own variables, set out in standards such as ISO 9606-1.
ASME Section IX sorts procedure variables into three categories. Essential variables, changed beyond the qualified range, call for a new or another supporting qualification record. Supplementary essential variables apply only when the construction code requires impact testing, and an increase in heat input above the qualified value is the usual example. Nonessential variables can be changed by revising the WPS, with no new test. On the ISO route, the procedure test states the limits as a range of qualification (ISO 15614-1 for arc and gas welding of steels and arc welding of nickel and nickel alloys, other parts of the series for other materials and processes), and the two routes are not interchangeable. The full assignment, process by process and edition by edition, is for the code’s variable tables; the cases below are examples to confirm there.
Worked example: two changes in one week
A shop holds a Section IX qualification record for a GMAW procedure. Two changes arrive in the same week.
- The job moves to a base metal with a P-Number the qualification record does not qualify.
- The shielding gas flow is raised above the flow-rate range the WPS states.
The first is the classic essential variable. A base metal the record does not qualify is outside the record, so a new test or a supporting record comes before the first production weld. On the ISO route the same move is checked against the parent material group in the range of qualification. The second is a nonessential variable in the Section IX tables for GTAW and GMAW/FCAW, as the Section IX guide sets out, so the WPS is revised and welding carries on with no new test. Confirm both in the edition your code invokes.
Same shop, same week, opposite outcomes, and neither can be judged from the look of the bead. What separates an essential variable from its nearest neighbour, the nonessential variable, is whether the code treats the change as able to affect the properties the qualification proved, and the code’s tables answer that for each process. A travel speed limit on a WPS is one place the question comes up; see travel speed range (WPS).
Where you meet this term
- Procedure qualification planning, where the test-weld conditions are chosen so the record covers the range production will use
- Change control on the shop floor, where a proposed substitution is checked against the code's variable tables before it is approved
- Requalification decisions, where a change outside the qualified range leads to a new test or a supporting record
- Audits, where the production record is checked against the range the qualification supports